How to Wire PCON CA – Wiring Controller for IAI Electric Actuator – ROBO Cylinder
https://www.intelligentactuator.com/controllers-teach-catalogs/
Accessary Connector (Plug)
0V is connected to “0V”…
Use AWG16 Wire…
24V is connected to “24V”…
Again, Use AWG16 Wire…
MPI and M10 Should come Jumpered…
24V from Controllers goes to the Motor…
Use AWG20 Wire for S1, S2, EMG-, BKRLS…
24V goes to S1, which is connected to S2 internally…
S2 is connected to EMG-…
– see details on the video —
Field Network Controllers
ROBO Cylinder Position Controller PowerCON 150: PCON-CA
ROBO Cylinder Position Controller High-thrust Motor Type: PCON-CFA
1: Supporting seven major eld networks
DeviceNet, CC-Link, PROFIBUS-DP, CompoNet, MECHATROLINK (I, II), EtherCAT and EtherNet/IP are supported. Key
features include wire-saving, direct numerical specication, position number specication, and current position read.
2: PCON-CFA for high-thrust motors
Supported Actuators:
PCON-CA: ROBO Cylinder RCP4 / RCP3 / RCP2 series
PCON-CFA: ROBO Cylinder RCP2-RA8C / RA8R / RA10C / HS8C / HS8R series, ROBO Cylinder splash-proof RCP2W-SA16C / RA10C series
Field Network Type:
DeviceNet, CC-Link, PROFIBUS-DP, CompoNet, MECHATROLINK, EtherCAT, EtherNet/IP
Post time: Jun-12-2017